Hyundai Sonata LF Quiz
Body (Interior and Exterior)

Rear Seat Cushion Cover Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 90Engine Electrical System — 58Emission Control System — 24Engine Control System/Fuel System — 114Drive Shaft and Axle — 15Suspension System — 35Steering — 19Restraints — 50Brake System — 54Body (Interior and Exterior) — 213Body Electrical System — 241Heating, Ventilation, and Air Conditioning — 56DCT (Dual Clutch Transmission) System — 52
4steps
~29min
2/5difficulty
1special tools
Done 0 of 4

Replacement
  • Wear gloves to protect your hands.
  • When prying with a flat-tip screwdriver or a trim tool, wrap the tool with protective tape and apply protective tape to the surrounding parts to prevent damage.
  • Use a plastic panel removal tool to remove the interior trim parts so as not to damage the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")
  2. After loosening the mounting screws, remove the rear ISOFIX bracket (A).
  3. Remove the clips on the rear of the seat cushion cover, then remove the rear seat cushion cover (A). [Front side]
    [Rear]
  4. Install in the reverse order of removal.
    • To prevent wrinkles, make sure the material is evenly stretched over the cover (B) before installing the clips (A).
    • Replace the ring clips with new ones using the special service tool (C) (09880-4F000).

Test yourself

A quick Hyundai Sonata LF quiz: every answer comes with an explanation and a link to the manual page.