Engine stop switch inspection

Inspect the engine stop switch in the following procedures:

1. 1
   turn the ignition switch off.
2. 2
   Remove the air cleaner box. Refer to “air cleaner box removal and installation” in section 1d .
3. 3
   Disconnect the right handlebar switch coupler (1).

   

4. Inspect the engine stop switch for continuity with a tester.

If any abnormality is found, replace the right handlebar switch assembly with a new one. Refer to “handlebar removal and installation” in section 6b .

Special tool : 09900–25008 (multi circuit tester
set)

Tester knob indication continuity ( )

5. After finishing the engine stop switch inspection, reinstall the removed parts.

Refer to “ignition switch inspection” in section 9c .