Front wheel removal

1. Place the motorcycle on the side stand.

2. Remove both brake calipers from the front forks by removing two mounting bolts 1 on each calipers.

Note

: never squeeze the front brake lever with the caliper removed. It is very difficult to force the pads back into the caliper assembly and brake fluid leakage may result.

1. 1
   Remove the bolts 2.
2. 2
   Loosen the axle holder bolts 3.

   

1. 1
   Loosen the axle holder bolts 4.
2. 2
   Place an accessory service stand or equivalent under the swing arm to help stabilize the rear end.
3. 3
   Carefully position a jack under the exhaust pipe and raise until the front wheel is slightly off the ground.

Caution Improper jacking may cause damage to the fairing or oil filter.

Do not apply the jack head to the fairing lower part or the oil filter when jacking up the motorcycle.

8. Draw out the axle shaft.

1. 1
   Slide the front wheel forward.
2. 2
   To reinstall the wheel assembly, reverse the sequence as described.

   

1. 1
   Hold the shaft and tighten the bolt 5 to the specified torque.
2. 2
   Tighten the axle holder bolts 6 to the specified torque.
3. 3
   Move the steering up and down several times.
4. 4
   Tighten the axle holder bolts 7 To the specified torque.
5. 5
   After installing the wheel, apply the brake several times to restore the proper lever stroke.

Warning
Failure to extend brake pads after installing the wheel can cause poor braking performance and may result in an accident.

Before riding, "pump" the brake repeatedly until brake pads are pressed against the brake disks and proper lever/ pedal stroke and firm feel are restored. Also check that the wheel rotates freely.

Warning
Installing the front wheel in the reverse direction can be hazardous. The tire for this motorcycle is directional. Therefore, the motorcycle may have unusual handling if the wheel is installed incorrectly.

Install the front wheel in a specified direction, as indicated by the arrow on the sidewall of the tire.

Warning
Failure to torque bolts and nuts properly could lead to an accident.

Torque bolts and nuts to the proper specifications. If you are not sure of the proper procedure, have your authorized suzuki dealer or qualified mechanic do this.

Front axle tightening torque: 100 N·m

Front axle holder bolt tightening torque: 23 N·m

Front brake caliper mounting bolt tightening torque: 39 N·m