Fuel pump relay inspection

Refer to “electrical components location” in section 0a .

Inspect the fuel pump relay in the following procedures:

1. 1
   remove the frame covers. Refer to “exterior parts removal and installation” in section 9d (page 9d- 6).
2. 2
   Remove the fuel pump relay (1).

   

3. First, check for insulation with the tester between terminals “a” and “b”. Next, check for continuity between “a” and “b” with 12 v voltage applied, positive (+) to terminal “c” and negative (–) to terminal “d”. If continuity does not exist, replace the relay with a new one.

Special tool : 09900–25008 (multi circuit tester
set)

Tester knob indication continuity test ( )

Refer to “fuel line inspection” in section 0b (page 0b- 10).

Refer to “fuel level gauge inspection” in section 9c .