Oil cooler / oil cooler hose removal and installation

Refer to “electrical components location” in section 0a .

1. 1
   Turn the ignition switch off.
2. 2
   Remove the left side cowling. Refer to “exterior parts removal and installation” in section 9d .
3. 3
   Drain engine oil. Refer to “engine oil and filter replacement” in section 0b .
4. 4
   Disconnect the oil pressure switch lead wire (1).
5. 5
   Remove the oil pressure switch (2).

   

1. Apply bond to the thread part of oil pressure switch and tighten oil pressure switch to the specified torque.

Note be careful not to apply bond to the hole of thread end.

2. Route the oil pressure switch lead wire properly and tighten the screw to the specified torque. Refer to “wiring harness routing diagram” in section 9a .

1. 1
   Pour engine oil. Refer to “engine oil and filter replacement” in section 0b .
2. 2
   Install the removed parts.

Refer to “oil pressure indicator inspection” in section 9c .