Engine
Diagnostic information and procedures
In this manual: Engine
9steps
~54min
2/5difficulty
Done 0 of 9
Engine lubrication symptom diagnosis

Oil pressure check


Oil pressure check
Check the engine oil pressure periodically. This will give a good indication of the condition of the moving parts.
Notebefore checking the oil pressure, check the following.
- Oil level (refer to “engine oil and filter replacement” in section 0b .)
- Oil leaks (if leak is found, repair it.)
- Oil quality (if oil is discolored or deteriorated, replace it.)
- Start the engine and check if the oil pressure indicator light is turned on. If the light stays on, check the oil pressure indicator light circuit. If the circuit is ok, check the oil pressure in the following manner.
- Remove the left side cowling. Refer to “exterior parts removal and installation” in section 9d .
- Remove the oil pressure switch lead wire (1) and oil pressure switch (2).

- Install the special tools to the mounting hole of the oil pressure switch.
- Install the oil pressure switch (2) to the adapter.

- Warm up the engine as follows: summer: 10 min. At 2 000 r/min winter: 20 min. At 2 000 r/min
- after warming up, increase the engine speed to 3 000 r/min (observe the tachometer), and read the oil pressure gauge.
If the oil pressure is lower or higher than the specification, the following causes may be considered.
| High oil pressure | Low oil pressure |
|
|
- Stop the engine and remove the oil pressure gauge and attachment.
- Reinstall the oil pressure switch. Refer to “oil pressure switch removal and installation” .
- Check the engine oil level. Refer to “engine oil and filter replacement” in section 0b .
- Install the left side cowling. Refer to “exterior parts removal and installation” in section 9d (page 9d- 6).
Test yourself
A quick Suzuki GSX-R 1000 quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?