Rear brake light switch inspection

Inspect the rear brake light switch in the following procedures:

1. 1
   lift and support the fuel tank. Refer to “fuel tank removal and installation” in section 1g (page 1g- 9).
2. 2
   Disconnect the rear brake light switch lead wire coupler (1).

   

3. Inspect the rear brake light switch for continuity with the tester.

   If any abnormality is found, replace the rear brake light switch with a new one.

Special tool : 09900–25008 (multi circuit
tester set)

1. 1
   Connect the rear brake light switch lead wire coupler.
2. 2
   Reinstall the fuel tank. Refer to “fuel tank removal and installation” in section 1g .