Installation

HINT:

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

(a) Apply MP grease to a new O-ring.

(b) Install the O-ring to the axle hub.

NOTICE:

Do not damage the O-ring.

(c) Install the disc brake dust cover and axle hub to the steering knuckle with the 4 bolts.

Torque:

80 N·m {816 kgf·cm, 59 ft·lbf}

2. INSTALL FRONT DISC

3. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH

4. INSTALL FRONT WHEEL

Torque:

for aluminum wheel :

103 N·m {1050 kgf·cm, 76 ft·lbf}

for steel wheel :

112 N·m {1142 kgf·cm, 83 ft·lbf}

5. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust the front wheel alignment (See page ).

6. CHECK SPEED SENSOR SIGNAL

(a) Inspect the speed sensor signal (See page
).