Power Window Master Switch

Components COMPONENTS ILLUSTRATION
Removal REMOVAL PROCEDURE

1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

4. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

5. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

(a) Disconnect the connector.

(b) Detach the 10 claws from the backside and remove the multiplex network master switch with base panel.

(c) Remove the 3 screws and multiplex network master switch assembly.

Inspection INSPECTION PROCEDURE

1. INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

(a) Check that the LED illuminates.

(1) Apply battery voltage to the master switch and check that the LEDs illuminate.

OK:

Measurement Condition	Specified Condition
Battery positive (+) → 18 (LED) Battery negative (-) → 12 (GND)	LEDs illuminate

• If the result is not as specified, replace the multiplex network master switch assembly.

Text in Illustration

*a	Component without harness connected (Multiplex Network Master Switch Assembly)
*b	LED

Installation INSTALLATION PROCEDURE

1. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

(a) Install the multiplex network master switch assembly with the 3 screws.

(b) Attach the 10 claws to install the multiplex network master switch with base panel.

(c) Connect the connector.

2. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

4. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

6. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH