Rear Power Window Switch

Components COMPONENTS ILLUSTRATION
Inspection INSPECTION PROCEDURE

1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 6 (UP) - 1(GND) Manual up operation Below 1 Ω 7 (DOWN) - 1 (GND) Manual down operation Below 1 Ω 8 (AUTO) - 1 (GND) Auto up/down operation Below 1 Ω 6 (UP) - 1 (GND) Not operated 10 kΩ or higher 7 (DOWN) - 1 (GND) Not operated 10 kΩ or higher 8 (AUTO) - 1 (GND) Not operated 10 kΩ or higher If the result is not as specified, replace the rear power window regulator switch assembly.

(b) Check that the LED illuminates.

(1) Apply battery voltage to the power window regulator switch and check that the LED illuminates.

OK:

Measurement Condition	Specified Condition
Battery positive (+) → 4 (LED) Battery negative (-) → 1 (GND)	LED illuminates

• If the result is not as specified, replace the rear power window regulator switch assembly.

Text in Illustration

*1	LED
*a	Front view of wire harness connector (Power Window Regulator Switch Assembly)

Removal REMOVAL PROCEDURE

1. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

3. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

(a) Detach the 10 claws from the backside and remove the power window regulator switch with base panel.

(b) Disconnect the connector.

(c) Detach the 2 claws and remove the power window regulator switch.

Installation INSTALLATION PROCEDURE

1. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

(a) Attach the 2 claws to install the power window regulator switch assembly to the base panel.

(b) Connect the connector.

(c) Attach the 10 claws to the install the power window regulator switch with base panel.

2. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

4. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH