Brake Control / Dynamic Control Systems

Steering Angle Sensor

~2min read

Components

COMPONENTS

ILLUSTRATION

*1

SPIRAL CABLE SUB-ASSEMBLY

*2

STEERING ANGLE SENSOR

Removal

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed once parts have been removed, installed, or replaced during removal/installation of the spiral cable sub-assembly with sensor are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

Initialize Back Door Lock

Door Lock Control System

HINT:

  • Follow the same procedure for both RHD and LHD vehicles.
  • The following procedure applies to LHD vehicles.

PROCEDURE

1. REMOVE SPIRAL CABLE SUBASSEMBLY WITH SENSOR

Click here

2. REMOVE STEERING ANGLE SENSOR

(a) Release the claws and the pins, then remove the steering angle sensor spiral cable sub-assembly.

NOTICE:

Take care not to damage the pins or guides of the steering angle sensor spiral cable sub-assembly.

*a

Guide

Installation

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Follow the same procedure for both RHD and LHD vehicles.
  • The following procedure applies to LHD vehicles.

PROCEDURE

1. INSTALL STEERING ANGLE SENSOR

(a) Align the guides and pins, then engage the claws to install the steering angle sensor onto the spiral cable sub-assembly.

NOTICE:

  • Do not remove the lock pin until the steering angle sensor is installed onto the spiral cable sub-assembly.
  • Take care not to damage the pins or guides of the steering angle sensor spiral cable sub-assembly.
  • The spiral cable sub-assembly can rotate 30 degrees even when the interlock is engaged. Therefore, make sure that both guides are correctly aligned when installing the steering angle sensor onto the spiral cable sub-assembly.

*a

Guide

*b

Pin

*c

Lock pin

(b) Remove the lock pin from the steering angle sensor.

2. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR

Click here