Audio / Video

Removal

~1min read

REMOVAL

PRECAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side as for the LH side.
  • The procedure described below applies to the LH side.

PROCEDURE

1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL CLIP

Click here

2. REMOVE MULTIPLEX NETWORK MAIN SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for driver side)

Click here

3. REMOVE POWER WINDOW SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for front passenger side)

Click here

4. REMOVE FRONT DOOR TRIM PANEL SUB-ASSEMBLY

Click here

5. REMOVE FRONT SPEAKER NO. 1 ASSEMBLY

(a) Disconnect the connector.

(b) Using a drill with a bit smaller than 5 mm (0.197 in.) in diameter, drill 3 rivet heads.

NOTICE:

  • Do not touch the speaker cone.
  • Do not drill the rivet at an angle as this may damage the drill and the rivet hole. Align the drill with the rivet, then carefully drill the rivet head.
  • Be careful as the drilled rivet is hot.

(c) Continue drilling and push out the remaining rivet fragments.

(d) Using a vacuum cleaner, remove the rivet fragments and shavings from inside the door.

(e) Release the claw and guide to remove the front speaker No. 1 assembly.