Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during power seat lumbar support switch (front) removal/installation are shown below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Necessary Procedures | Effects / Inoperative Function When Necessary Procedure Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
CAUTION:
- Be sure to read the Precautions carefully before performing maintenance.
Click here
.gif)
.png)
- Wear protective gloves. Sharp edges on parts may cause injury to your hands.
HINT:
The power seat lumbar support switch (front) is only available on the driver side.
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY
Click here![]()
2. DISCONNECT FRONT SEAT BACK COVER (SEPARATE TYPE) WITH PAD
Click here
![]()
3. REMOVE SEAT HEIGHT ADJUSTER HANDLE
Click here
![]()
4. REMOVE RECLINING ADJUSTER OUTER HINGE COVER
Click here
![]()
5. REMOVE RECLINING ADJUSTER RELEASE HANDLE
Click here
![]()
6. REMOVE SEAT ADJUSTER COVER
Click here
![]()
7. REMOVE FRONT SEAT CUSHION SHIELD
Click here
![]()
8. REMOVE FRONT POWER SEAT LUMBAR SUPPORT SWITCH
(a) Remove the 2 screws. |
![]() |
(b) Release the guides to remove the front power seat lumbar support switch.
