Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during lumbar support adjuster assembly removal/installation are shown below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Necessary Procedures | Effects / Inoperative Function When Necessary Procedure Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
CAUTION:
- Be sure to read the Precautions carefully before performing maintenance.
.gif)
.png)
- Wear protective gloves. Sharp edges on parts may cause injury to your hands.
HINT:
The lumbar support adjuster assembly is only available on the driver side.
PROCEDURE
1. REMOVE FRONT SEAT BACK SEPARATE TYPE COVER WITH PAD
Click here![]()
2. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY
(a) Disconnect the connector. |
![]() |
(b) Release the clip.
(c) Release the claws to detach the 2 front seat back edge protectors from the front seat back frame subassembly. |
![]() |
(d) Release the guides to remove the lumbar support adjuster assembly from the front seat back frame subassembly as shown in the illustration.
![]() |
Remove in this direction |
(e) Remove the 2 front seat back edge protectors from the lumbar support adjuster assembly. |
![]() |


.png)
