Supplemental Restraint Systems

Removal

~3min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during removal/installation of the No. 2 side airbag sensor are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. PRECAUTIONS

CAUTION:

Be sure to read the Precautions carefully before performing maintenance.

Click here

NOTICE:

After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.

Click here

2. DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL

Click here

CAUTION:

  • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  • If any Supplemental Restraint System (SRS) component is accidentally deployed, serious injury may result.

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

3. REMOVE REAR SEAT ASSEMBLY

Click here

4. REMOVE REAR DOOR SCUFF PLATE (with rear seat side airbag)

Click here

5. REMOVE REAR DOOR SCUFF PLATE (without rear seat side airbag)

Click here

6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

HINT:

Disconnect the rear door opening trim weatherstrip so that the rear seat side garnish can be removed.

7. REMOVE REAR SEAT BACK HINGE SUB-ASSEMBLY

Click here

8. REMOVE REAR PILLAR GARNISH (with rear seat side airbag)

Click here

9. REMOVE REAR SEAT SIDE GARNISH (with rear seat side airbag)

Click here

10. REMOVE REAR SEAT SIDE GARNISH (without rear seat side airbag)

Click here

11. REMOVE NO. 2 SIDE AIRBAG SENSOR

(a) Make sure the ignition switch is in the OFF position.

(b) Make sure the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Remove the bolt and release the claw to detach the No. 2 side airbag sensor.

(d) Disconnect the connector to remove the No. 2 side airbag sensor.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.

(1) Push the white housing lock and slide the yellow CPA. (At this stage, the connector cannot be disconnected.)

*a

White housing lock

*b

Yellow CPA

*c

Slide

*d

Push in

(2) Push the white housing lock again and disconnect the connector.

NOTICE:

Do not press the part (A) shown in the illustration when disconnecting the connector.

(e) After disconnecting the connector, make sure the white housing lock is in the position shown in the illustration.

*a

Correct

*b

Incorrect