Supplemental Restraint Systems

Installation

~3min read
0102030405097N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL NO. 2 SIDE AIRBAG SENSOR

(a) Make sure the ignition switch is in the OFF position.

(b) Make sure the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Before connecting the connector, make sure the white housing lock is in the position shown in the illustration.

*a

Correct

*b

Incorrect

(d) Connect the connector to the No. 2 side airbag sensor.

*a

White housing lock

*b

Connect

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.

HINT:

  • Be sure to connect the connector until it locks (when locking, make sure a click is heard).
  • When the connector is locked, the white housing lock will slide. Do not hold the white housing lock or part (A), as this may cause improper connection.

(e) Engage the claw, then install the No. 2 side airbag sensor using the bolt.

Torque:

9 N·m {92 kgf·cm, 80 in·lbf}

NOTICE:

  • If the No. 2 side airbag sensor has been dropped, or if the housing or connector has cracks, nicks or other defects, replace it with a new one.
  • When installing the No. 2 side airbag sensor, make sure the SRS wiring does not interfere with or get pinched between other parts.
  • Make sure the claw of the No. 2 side airbag sensor is properly inserted into the body hole.

(f) Make sure the installed parts of the No. 2 side airbag sensor are not loose.

2. INSTALL REAR SEAT SIDE GARNISH (with rear seat side airbag)

Click here

3. INSTALL REAR SEAT SIDE GARNISH (without rear seat side airbag)

Click here

4. INSTALL REAR PILLAR GARNISH (with rear seat side airbag)

Click here

5. INSTALL REAR SEAT BACK HINGE SUB-ASSEMBLY

Click here

6. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

7. INSTALL REAR DOOR SCUFF PLATE (with rear seat side airbag)

Click here

8. INSTALL REAR DOOR SCUFF PLATE (without rear seat side airbag)

Click here

9. INSTALL REAR SEAT ASSEMBLY

Click here

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click here

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

11. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here

12. CHECK SRS WARNING LIGHT

Click here