Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures required (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during rear seat airbag removal/installation are shown below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Necessary Procedures | Effects / Inoperative Function When Necessary Procedure Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
HINT:
- Perform the same procedure for the right and left sides.
- The following procedure applies to the left side.
PROCEDURE
1. PRECAUTIONS
CAUTION:
Be sure to read the Precautions carefully before performing maintenance.
Click here
![]()
NOTICE:
After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.
Click here
![]()
2. REMOVE REAR SEAT SIDE GARNISH
Click here
![]()
3. REMOVE REAR SEAT AIRBAG
CAUTION:
When storing the rear seat airbag, make sure the deployment side is facing upward.
![]() |
Deployment side |
(a) Remove the 2 screws. |
![]() |
(b) Release the claws to remove the rear seat airbag.
NOTICE:
Take care not to damage the deployment surface of the rear seat airbag.
.gif)
.png)
