Rear Suspension

Removal

2steps
~17min
2/5difficulty
1special tools
Done 0 of 2

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed or replaced during removal/installation of the rear shock absorber assembly are shown below.

Procedures Required After Replacement / Removal / Installation of Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Rear Wheel Alignment Adjustment

  1. Clear the zero point calibration data.
  2. Perform zero point calibration of the yaw rate and acceleration sensor.
  • DTCs are stored
  • ABS warning light comes on
  • Skid control warning light comes on
  • VSC OFF or malfunctioning

Removal/installation of rear left height control sensor sub-assembly*1

Initialize LH Headlight ECU Sub-assembly

Automatic Headlight Leveling System

Suspension, tires, etc.

(Vehicle height changes due to suspension or tire replacement)*1

  • *1: with height control sensor

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. REMOVE REAR WHEEL

Click here

2. REMOVE REAR LEFT HEIGHT CONTROL SENSOR SUB-ASSEMBLY (with height control sensor)

Click here

3. DISCONNECT REAR SHOCK ABSORBER ASSEMBLY

(a) Remove the 2 bolts and disconnect the rear shock absorber assembly from the vehicle.

4. LOOSEN REAR SHOCK ABSORBER ASSEMBLY

(a) Loosen the nut of the rear shock absorber assembly.

NOTICE:

Hold the rear axle carrier pin while turning the nut.

*1

Rear Axle Carrier Pin

5. REMOVE REAR STABILIZER LINK ASSEMBLY

Click here

6. DISCONNECT REAR UPPER CONTROL ARM ASSEMBLY

(a) Remove the bolt and nut, and disconnect the rear upper control arm assembly from the rear axle carrier sub-assembly.

NOTICE:

Do not turn the nut as it has a stopper. Loosen the bolt with the nut in place.

7. REMOVE REAR SHOCK ABSORBER ASSEMBLY

(a) Remove the nut and the rear shock absorber assembly from the rear axle carrier assembly.

NOTICE:

Hold the rear axle carrier pin while turning the nut.

*1

Rear Axle Carrier Pin

8. REMOVE REAR SHOCK ABSORBER CAP

(a) Using a screwdriver with its tip wrapped in protective tape, remove the rear shock absorber cap from the rear shock absorber assembly.

*a

Protective tape

9. REMOVE REAR SUSPENSION SUPPORT ASSEMBLY

(a) Secure the rear shock absorber assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.

*a

Turn

*b

Hold

(b) Using the SST and a 6 mm hex socket, hold the rear shock absorber rod and remove the nut between the rear support and the rear shock absorber.

SST: 09729-97202

(c) Remove the rear suspension support assembly from the rear shock absorber assembly.