Front Suspension

Removal

2steps
~12min
1/5difficulty
Done 0 of 2

REMOVAL

PRECAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts have been removed and installed or replaced during front stabilizer bar removal/installation are shown below.

Procedures Required After Replacement / Removal / Installation of Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Front wheel alignment adjustment

  1. Clear the zero point calibration data.
  2. Perform zero point calibration of the yaw rate and acceleration sensor.
  • DTCs are stored
  • ABS warning light comes on
  • Skid control warning light comes on
  • VSC OFF or malfunctioning

Suspension, tires, etc.

(Vehicle height changes after replacing the suspension or tires)

Initialize Left Headlight ECU Sub-assembly No. 1

Automatic Headlight Leveling System

PROCEDURE

1. REMOVE FRONT SUSPENSION MEMBER SUB-ASSEMBLY

Click here

2. REMOVE STEERING LINKAGE ASSEMBLY

(a) Remove the 2 bolts, 2 nuts and steering linkage assembly from the front suspension member sub-assembly.

NOTICE:

Do not turn the nut as it has a stopper. Loosen the bolt with the nut in place.

3. REMOVE LEFT FRONT STABILIZER LINK ASSEMBLY

(a) Remove the left front stabilizer link assembly from the left front stabilizer bar.

4. REMOVE RIGHT FRONT STABILIZER LINK ASSEMBLY

HINT:

Perform the same procedure as for the left side.

5. REMOVE NO. 1 FRONT STABILIZER BAR BRACKET LH

(a) Remove the 2 bolts and left front stabilizer bar bracket from the front suspension member sub-assembly.

6. REMOVE NO. 1 FRONT STABILIZER BAR BRACKET RH

HINT:

Perform the same procedure as for the left side.

7. REMOVE FRONT STABILIZER BAR

(a) Remove the front stabilizer bar with the 2 front stabilizer bar bushings from the front suspension member sub-assembly.

8. REMOVE FRONT STABILIZER BAR BUSHING LH

(a) Remove the left front stabilizer bar bushing from the front stabilizer bar.

9. REMOVE FRONT STABILIZER BAR BUSHING RH

HINT:

Perform the same procedure as for the left side.