Front Suspension

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT FRONT STABILIZER LINK ASSEMBLY

(a) Inspect the ball joint swivel torque.

(1) Clamp the front stabilizer link assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.

(2) Install the nut onto the stud of the front stabilizer link assembly.

(3) Using a torque wrench, turn the stud continuously at a rate of one turn every 3 to 5 seconds, and read the torque value on the 5th turn.

Rotation torque:

0.05 to 1.96 N*m (0.6 to 19 kgf*cm, 0.5 to 17 lbf*in)

HINT:

If the rotation torque is not within the specified range, replace the front stabilizer link assembly with a new one.

(4) Turn the stud to make sure that the stud does not bind and that there is no play.

HINT:

If the stud sticks or has play when it turns, replace the front stabilizer link assembly with a new one.

(b) Inspect the dust boot.

(1) Check that the dust boot is not cracked and has no grease on it.

HINT:

If the brake dust boot is cracked or there is grease leakage inside it, replace the front stabilizer link assembly with a new one.