Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT STABILIZER BAR BUSHING LH
(a) Install the front stabilizer bar bushing LH onto the front stabilizer bar as shown in the illustration.
*a |
Cutout |
*b |
Stopper |
![]() |
Front of Vehicle |
![]() |
Outside the Vehicle |
NOTICE:
- Install the front stabilizer bar bushing LH so that the cutout faces the rear of the vehicle.
- Install the front stabilizer bar bushing bracket LH onto the front stabilizer bar so that the front stabilizer bar stopper ring faces the outside of the vehicle.
2. INSTALL FRONT STABILIZER BAR BUSHING RH
HINT:
Perform the same procedure as for the left side.
3. INSTALL FRONT STABILIZER BAR
(a) Install the front stabilizer bar with the 2 front stabilizer bar bushings onto the front suspension crossmember sub-assembly.
NOTICE:
Make sure the identification mark faces the right side of the vehicle.
*a |
Identification mark |
- |
- |
![]() |
Front of Vehicle |
- |
- |
4. INSTALL FRONT STABILIZER BAR BRACKET LH NO. 1
(a) Install the front stabilizer bar bracket LH No. 1 onto the front suspension crossmember sub-assembly using the 2 bolts.
Torque:
103 N·m {1 050 kgf·cm, 76 ft·lbf}
NOTICE:
- Be sure to install the front stabilizer bar bracket LH No. 1 with its arrow facing the front of the vehicle.
- Temporarily tighten bolt (B), then fully tighten the 2 bolts in the order of (A) and (B).
*a |
Arrow |
![]() |
Front of Vehicle |
5. INSTALL FRONT STABILIZER BAR BRACKET RH NO. 1
HINT:
Perform the same procedure as for the left side.
6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
(a) Install the front stabilizer link assembly LH onto the front stabilizer bar LH with the nut.
Torque:
74 N·m {755 kgf·cm, 55 ft·lbf}
HINT:
If the ball joint turns together with the nut, hold the stud with a 6 mm hexagon socket wrench.
7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT:
Perform the same procedure as for the left side.
8. INSTALL STEERING TIE ROD ASSEMBLY
(a) Install the steering tie rod assembly onto the front suspension crossmember sub-assembly with the 2 new bolts and 2 new nuts.
Torque:
133 N·m {1,356 kgf·cm, 98 ft·lbf}
NOTICE:
- Do not turn the nut as it has a stopper. Tighten the bolt with the nut in place.
- Be sure to tighten the bolts starting from the left side of the vehicle.
9. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
Click here
![]()
.png)
.png)