Wiper / Washer

Wiper ECU

~1min read
0102030405012.59N·mlb·ft
Tightening torque found on this page

Removal

REMOVAL

PRECAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, and initialization or registration) must be performed once this part has been removed and installed, or the front wiper relay assy has been replaced during removal/installation. The required procedures are shown below.

Necessary Procedures After Parts Removal / Installation / Replacement

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

PROCEDURE

1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here

2. REMOVE FRONT WIPER RELAY ASSY

(a) Disconnect the connector.

(b) Remove the bolt.

(c) Release the guide to remove the front wiper relay assy.

Components

COMPONENTS

ILLUSTRATION

*1

WIPER RELAY ASSY

-

-

N*m (kgf*cm, lbf*in): Specified torque

-

-

Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT WIPER RELAY ASSY

(a) Engage the guide and install the front wiper relay assy with the bolt.

Torque:

12.5 N·m {127 kgf·cm, 9 ft·lbf}

(b) Connect the connector.

2. INSTALL INSTRUMENT PANEL PAD SUB-ASSY

Click here