Wiper / Washer

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT LEVEL WARNING SWITCH ASSY

HINT:

This inspection must be performed with the level warning switch assy installed on the washer reservoir.

(a) Fill the washer reservoir with washer fluid.

*a

Component without wire harness connected

(level warning switch assy)

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

1 (S) - 2 (E)

The fluid volume is 600 to 800 cm3 (36.6 to 48.8 cu in) minimum*

10 kΩ minimum

The fluid volume is 600 to 800 cm3 (36.6 to 48.8 cu in) maximum*

Below 1 Ω

HINT:

*: The level warning switch assy starts to operate when the fluid volume is 600 to 800 cm3 (36.6 to 48.8 cu in), depending on vehicle conditions.

If the result is not as specified, replace the level warning switch assy.