Trip information

~3min read
  • Instantaneous fuel consumption (graphic display/numeric display)*1
    Displays the current fuel consumption rate.
  • Average fuel consumption (after reset*2/after engine start/after refueling)*1
    Displays the average fuel consumption since the function was reset, since the engine was started, and since the vehicle was refueled, respectively.
    Use the displayed average fuel consumption as a reference value.
  • Average vehicle speed (after reset*2/after engine start)*1
    Displays the average vehicle speed since the function was reset and since the engine was started, respectively.
  • Elapsed time (after reset*2/after engine start)*1
    Displays the elapsed time since the function was reset and since the engine was started, respectively.
  • Distance (driving range/after engine start)*1
    Displays the estimated maximum distance that can be driven with the remaining fuel, and the distance driven since the engine was started, respectively.
    • This distance is calculated based on the average fuel consumption. Therefore, the actual distance you can drive may differ from the displayed distance.
    • If you add only a small amount of fuel, the display may not update.

      When refueling, turn the engine switch off. If you refuel the vehicle without turning the engine switch off, the display may not update.

  • Stop & Start system operating time (if equipped)*3
    Shows the total time the engine has been stopped by the Stop & Start system during the current engine stop cycle.
  • Eco driving range indicator
  • Speedometer
    Shows the vehicle speed.
  • Dynamic torque control 4WD system display (4WD models)
  • Weaving alert (if equipped)
    Detects weaving of the vehicle within its lane, which is often associated with reduced driver alertness, and indicates this reduced alertness using a bar graph.

    The shorter the bar, the more likely the driver is to need rest.

    This display is part of the LDA (Lane Departure Alert) system with active steering assist. The display is active when the conditions for the lane wandering alert are met.

  • Display off
    The system shows a black screen.

*1: Can be programmed as Trip Information 1 and 2.
*2: Reset procedures:

  • Select a function to reset with the meter control switch, then press and holdToyota CH-R. Écran multifonctionnel (avec affichage couleur)to reset.
  • If more than one function can be reset, check boxes are displayed next to each one.

*3: Can be programmed as Trip Information 3.