Axle and Differential

Steering Knuckle

2steps
~12min
1/5difficulty
0408012016020013096N·mlb·ft
Tightening torque found on this page
Done 0 of 2

Components

COMPONENTS

ILLUSTRATION

*1

FRONT LOWER BALL JOINT ASSEMBLY

*2

STEERING KNUCKLE

*3

FRONT AXLE HUB SUBASSEMBLY

*4

FRONT DISC BRAKE DUST COVER

*5

COTTER PIN

-

-

Torque for "Main Areas Related to Basic Vehicle Performance" such as Driving/Turning/Stopping: N*m (kgf*cm, lbf*ft)

●

Non-reusable part

Removal

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts have been removed and installed or replaced, during steering knuckle removal/installation, are shown below.

Procedures Required After Replacement / Removal / Installation of Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Front wheel alignment adjustment

  1. Clear the zero point calibration data.
  2. Perform zero point calibration of the yaw rate and acceleration sensor.
  • DTCs are stored
  • ABS warning light comes on
  • Skid control warning light comes on
  • VSC OFF or malfunctioning

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. REMOVE FRONT AXLE ASSEMBLY

Click here

2. REMOVE FRONT LOWER BALL JOINT ASSEMBLY

Click here

3. REMOVE STEERING KNUCKLE

(a) Clamp the front axle assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.

(b) Remove the 3 bolts, front axle hub subassembly and front disc brake dust cover from the steering knuckle.

NOTICE:

  • Do not drop the front axle hub subassembly.
  • Be careful not to damage the speed sensor rotor or contact surfaces.
  • Do not allow foreign matter to contact the speed sensor rotor or contact surfaces.

Installation

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL STEERING KNUCKLE

(a) Clamp the steering knuckle between aluminum plates in a vise.

NOTICE:

Do not overtighten the vise.

(b) Install the front axle hub subassembly and front disc brake dust cover to the steering knuckle with the 3 bolts.

Torque:

130 N·m {1 326 kgf·cm, 96 ft·lbf}

NOTICE:

  • Be careful not to damage the speed sensor rotor or contact surfaces.
  • Do not allow foreign matter to contact the speed sensor rotor or contact surfaces.

2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY

Click here

3. INSTALL FRONT AXLE ASSEMBLY

Click here