Axle and Differential

Installation

~3min read
050100150200250135100N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. TEMPORARILY INSTALL REAR AXLE CARRIER SUB-ASSEMBLY

(a) Temporarily install the rear axle carrier sub-assembly to the rear upper control arm assembly using the bolt and nut.

NOTICE:

  • Insert the bolt with the threaded end facing the rear of the vehicle.
  • Do not turn the nut as it has a stopper. Tighten the bolt with the nut in place.

(b) Temporarily install the rear shock absorber assembly to the rear axle carrier sub-assembly using the nut.

NOTICE:

Hold the rear axle carrier pin while turning the nut.

(c) Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts.

Torque:

135 N·m {1 377 kgf·cm, 100 ft·lbf}

2. INSTALL HOSE BRACKET

(a) Install the hose bracket to the rear axle carrier sub-assembly using the bolt.

Torque:

29 N·m {296 kgf·cm, 21 ft·lbf}

3. TEMPORARILY INSTALL REAR SUSPENSION ARM ASSEMBLY NO. 1

Click here

4. INSTALL REAR COIL SPRING LOWER SEAT

Click here

5. INSTALL REAR COIL SPRING

Click here

6. STABILIZE SUSPENSION

Click here

7. INSTALL REAR UPPER CONTROL ARM ASSEMBLY

(a) Install the rear upper control arm assembly onto the rear axle carrier sub-assembly using the bolt.

Torque:

73 N·m {744 kgf·cm, 54 ft·lbf}

NOTICE:

Do not turn the nut as it has a stopper. Tighten the bolt with the nut in place.

8. INSTALL REAR SUSPENSION ARM ASSEMBLY NO. 1

Click here

9. INSTALL REAR SUSPENSION ARM ASSEMBLY NO. 2

(a) Install the No. 2 rear suspension arm assembly (rear axle carrier sub-assembly side) with the bolt.

Click here

10. INSTALL REAR SHOCK ABSORBER ASSEMBLY

Click here

11. INSTALL REAR STABILIZER BAR LINK ASSEMBLY

Click here

12. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

Click here

13. CONNECT SKID CONTROL SENSOR WIRE

Click here

14. INSTALL REAR DISC

Click here

15. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Click here

16. INSTALL REAR LEFT HEIGHT CONTROL SENSOR SUB-ASSEMBLY (with Height Control Sensor)

Click here

17. INSTALL REAR WHEEL

Click here

18. INSTALL REAR SUSPENSION ARM ASSEMBLY NO. 2

(a) Install the No. 2 rear suspension arm assembly (rear suspension member sub-assembly side) using the nut.

Click here

19. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Click here

20. INSPECT SPEED SENSOR SIGNAL

Click here

21. PERFORM INITIALIZATION (with Height Control Sensor)

Click here