Axle and Differential

Replacement

~3min read
1special tools
0408012016020010779N·mlb·ft
Tightening torque found on this page

REPLACEMENT

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. REMOVE REAR WHEEL

Click here

2. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY

(a) Disconnect the No. 2 parking brake cable assembly connector.

(b) Remove the bolt and disconnect the rear brake hose from the rear brake hose bracket.

(c) Remove the 2 bolts and separate the rear disc brake caliper assembly from the rear axle carrier sub-assembly.

NOTICE:

Using a cable or equivalent tool, support the rear disc brake caliper assembly to prevent it from hanging by the rear brake hose.

3. REMOVE REAR DISC

Click here

4. REMOVE REAR AXLE HUB BOLT

(a) Temporarily install 2 nuts onto the rear axle hub bolts as shown in the illustration.

Recommended lock nut:

Thread diameter: 12.0 mm (0.472 in.)

Thread pitch: 1.5 mm (0.0591 in.)

NOTICE:

Reinstall the nuts to prevent damage to the rear axle hub bolts.

*a

Lock nut

*b

Turn

*c

Hold

(b) Using the SST and a screwdriver or equivalent tool to hold the rear axle hub and bearing assembly, remove the rear axle hub bolt.

SST: 09611-12010

NOTICE:

Do not damage the threads of the rear axle hub bolts.

5. INSTALL REAR AXLE HUB BOLT

(a) Temporarily install a new rear axle hub bolt onto the rear axle hub and bearing assembly.

*a

Lock nut

*b

Washer

*c

Turn

*d

Hold

(b) Install a washer and a acorn nut onto the rear axle hub bolt as shown in the illustration.

Recommended lock nut:

Thread diameter: 12.0 mm (0.472 in.)

Thread pitch: 1.5 mm (0.0591 in.)

HINT:

Recommended washer thickness: 5 mm (0.197 in.) minimum.

(c) Using a screwdriver or equivalent tool to hold the rear axle hub and bearing assembly, install the rear axle hub bolt by tightening the nut.

NOTICE:

  • Reinstall the nuts to prevent damage to the rear axle hub bolts.
  • Do not damage the threads of the rear axle hub bolts.

(d) Remove the 3 nuts and washer from the 3 rear axle hub bolts.

6. INSTALL REAR DISC

Click here

7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

(a) Install the rear disc brake caliper assembly onto the rear axle carrier subassembly with the 2 bolts.

Torque:

107 N·m {1 091 kgf·cm, 79 ft·lbf}

(b) Install the rear brake hose to the rear brake hose bracket with the bolt.

Torque:

29 N·m {296 kgf·cm, 21 ft·lbf}

(c) Connect the No. 2 parking brake cable assembly connector.

8. INSTALL REAR WHEEL

Click here