Steering Column

Installation

~1min read
0204060801005037N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

NOTICE:

  • Do not replace the spiral cable sub-assembly with sensor while the battery is connected and the ignition switch is in the ON position.
  • Do not swap the spiral cable sub-assembly with sensor without the steering wheel installed while the battery is connected and the ignition switch is in the ON position.
  • Make sure the steering wheel assembly is installed and in the straight-ahead position when checking the steering angle sensor.

PROCEDURE

1. INSTALL STEERING WHEEL SWITCH ASSEMBLY

Click here

2. INSTALL CRUISE CONTROL MAIN SWITCH

Click here

3. INSTALL LOWER STEERING WHEEL COVER NO. 2

Click here

4. ALIGN FRONT WHEELS STRAIGHT AHEAD

5. INSPECT AND ADJUST SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR

Click here

6. INSTALL STEERING WHEEL ASSEMBLY

(a) Align the alignment marks on the steering wheel assembly and the main steering shaft to install the steering wheel assembly.

*a

Alignment Mark

(b) Install the steering wheel adjusting nut.

Torque:

50 N·m {510 kgf·cm, 37 ft·lbf}

(c) with steering heater:

(1) Connect the steering heater connector.

(d) Connect the 2 connectors to the spiral cable sub-assembly with sensor.

7. CHECK STEERING WHEEL CENTERING

8. INSTALL HORN BUTTON ASSEMBLY

Click here