Supplemental Restraint Systems

Installation

~2min read
0102030405097N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL FRONT AIRBAG SENSOR

(a) Make sure the ignition switch is in the OFF position.

(b) Make sure the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Before connecting the connector, make sure the white housing lock is in the position shown in the illustration.

*a

Incorrect

*b

Correct

(d) Connect the connector to the front airbag sensor.

*a

White housing lock

*b

The connection is complete.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.

HINT:

  • Be sure to connect the connector until it locks (when locking, make sure a click is heard).
  • When the connector is locked, the white housing lock will slide. Do not hold the white housing lock or part (A), as this may cause improper connection.

(e) Engage the claw, then install the front airbag sensor using the bolt.

Torque:

9 N·m {92 kgf·cm, 80 in·lbf}

NOTICE:

  • If the front airbag sensor has been dropped, or if the housing or connector shows cracks, nicks or other damage, replace it with a new one.
  • When installing the front airbag sensor, make sure the SRS wiring does not interfere with or get pinched between other parts.
  • Make sure the front airbag sensor pin (claw) is correctly inserted into the body hole.
  • Tighten the bolt while holding the front airbag sensor, as the front airbag sensor pin (claw) is fragile.

(f) Make sure the installed front airbag sensor parts are not loose.

2. CONNECT THE CABLE TO THE NEGATIVE BATTERY TERMINAL

Click here

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

3. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here

4. CHECK SRS WARNING LIGHT

Click here