Supplemental Restraint Systems

Inspection On Vehicle

~2min read

INSPECTION ON VEHICLE

PRECAUTION / NOTICE / HINT

CAUTION:

Be sure to follow the correct removal and installation procedures for the front airbag sensors.

PROCEDURE

1. INSPECT FRONT AIRBAG SENSOR (vehicle not involved in collision)

(a) Perform a diagnostic system check.

Click here

2. INSPECT FRONT AIRBAG SENSOR (vehicle involved in collision but airbag not deployed)

(a) Perform a diagnostic system check.

Click here

(b) Visually check the front airbag sensors for any defects if the front bumper of the vehicle or the area around it is damaged.

HINT:

Defects include the following:

  • Cracks in the sensor housing
  • Nicks in the sensor housing
  • Chips in the sensor housing
  • Cracks or other damage to the connector
  • Damage to the serial number

OK:

There are no defects.

If any defect is found, replace the front airbag sensor with a new one.

3. INSPECT FRONT AIRBAG SENSOR (vehicle involved in collision and airbag deployed)

(a) When the airbags have deployed due to a collision, be sure to replace all front airbag sensors in the damaged areas (all those requiring repair).

(b) Visually check the front airbag sensors in the undamaged areas for any defects.

HINT:

Defects include the following:

  • Cracks in the sensor housing
  • Nicks in the sensor housing
  • Chips in the sensor housing
  • Cracks or other damage to the connector
  • Damage to the serial number

OK:

There are no defects.

If any defect is found, or if a front airbag sensor has detected a severe collision, replace the front airbag sensor with a new one.