Rear Suspension

Installation

~2min read
03060901201507858N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL REAR STABILIZER BAR BUSHING

(a) Install the 2 rear stabilizer bar bushings onto the rear stabilizer bar.

NOTICE:

Make sure to install the rear stabilizer bar bushings so that each slit faces the front of the vehicle.

2. INSTALL NO. 1 REAR STABILIZER BAR BRACKET

(a) Install the 2 No. 1 rear stabilizer bar brackets onto the 2 rear stabilizer bar bushings.

NOTICE:

Make sure to install the No. 1 rear stabilizer bar brackets so that each arrow mark faces the front of the vehicle.

*a

Arrow mark

Front of Vehicle

3. INSTALL REAR STABILIZER BAR

(a) Install the rear stabilizer bar, 2 No. 1 rear stabilizer bar brackets and 2 rear stabilizer bar bushings onto the rear suspension member sub-assembly with the 4 bolts.

Torque:

78 N·m {795 kgf·cm, 58 ft·lbf}

NOTICE:

  • Make sure that the identification mark faces the right side of the vehicle.
  • Temporarily tighten bolt (A), then fully tighten the 2 bolts in the order (B) and (A).

*a

Identification mark

4. STABILIZE SUSPENSION

Click here

5. INSTALL REAR STABILIZER LINK ASSEMBLY LH

(a) Install the rear stabilizer link assembly LH using nut (A).

Torque:

75 N·m {765 kgf·cm, 55 ft·lbf}

HINT:

If the ball joint turns together with the nut, hold the stud with a 6 mm hexagon socket wrench.

(b) Install the rear stabilizer link assembly LH using the bolt and nut (B).

Torque:

75 N·m {765 kgf·cm, 55 ft·lbf}

NOTICE:

Do not turn the bolt as it has a stopper. Tighten the nut with the bolt in place.

6. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the left side.

7. INSTALL REAR WHEEL

Click here