Seat Belt

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT REAR LEFT SEAT BELT INNER BELT ASSEMBLY WITH CENTER BELT (with Seat Belt Reminder System)

(a) for LH side:

(1) Check the resistance.

Measure the resistance according to the value(s) specified in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

M32-4 (LBR+) - M32-5 (LBR-)

Rear left seat belt unbuckled

Below 1 Ω

Rear left seat belt buckled

10 kΩ minimum

If the result is not as specified, replace the rear left seat belt inner belt assembly with center belt.

*a

Component without wire harness connected

(Rear Left Seat Belt Inner Belt Assembly with Center Belt)

(b) for CENTER:

(1) Check the resistance.

Measure the resistance according to the value(s) specified in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

M33-1 (CBR+) - M33-2 (CBR-)

Rear center seat belt unbuckled

Below 1 Ω

Rear center seat belt buckled

10 kΩ minimum

If the result is not as specified, replace the rear left seat belt inner belt assembly with center belt.

*a

Component without wire harness connected

(Rear Left Seat Belt Inner Belt Assembly with Center Belt)