Door Lock

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT BACK DOOR LOCK ASSEMBLY

(a) Check the operation of the door lock motor.

(1) Set the door lock to the locked position.

*a

Component without wire harness connected

(back door lock assembly)

*b

Lock

*c

Unlock

(2) Apply battery voltage and check the operation of the door lock motor.

OK:

Battery connection

Result

Battery positive (+) → Terminal 1 (+) (ACT+)

Battery negative (-) → Terminal 2 (ACT-)

Unlock (open) function of the trunk door lock motor

If the result is not as specified, replace the back door lock assembly.

(b) Check the operation of the trunk door sill light switch.

(1) Measure the resistance according to the value(s) shown in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

2 (ACT-) - 3 (D+)

Locked

10 kΩ minimum

2 (ACT-) - 3 (D+)

Unlocked

Below 1 Ω

If the result is not as specified, replace the back door lock assembly.