Wiper / Washer
Inspection On Vehicle
In this manual: Wiper / Washer
~1min read
INSPECTION ON VEHICLE
PROCEDURE
1. INSPECT WASHER NOZZLE SUB-ASSY
(a) Operate the washer nozzle sub-assys and check the position where the washer fluid contacts the windshield.
Standard:
The washer fluid contacts the windshield within the areas shown in the illustration.
*a |
Upper limit |
*b |
Standard |
*c |
Lower limit |
- |
- |
![]() |
Measurement |
- |
- |
Standard measurement:
Area | Measurement | Area | Measurement |
|---|---|---|---|
A |
341.0 mm (13.43 in.) |
B |
187.0 mm (7.36 in.) |
C |
82.5 mm (3.25 in.) |
- |
- |
HINT:
If the result is not as specified, replace the washer nozzle sub-assy.
Was this page helpful?
.png)