Brake System (Other)
Inspection On Vehicle
In this manual: Brake System (Other)
~1min read
INSPECTION ON VEHICLE
PROCEDURE
1. CHECK BRAKE FLUID LEVEL IN RESERVOIR
Click here![]()
2. INSPECT BRAKE BOOSTER ASSEMBLY
Click here![]()
3. REMOVE COWL TOP OUTER PANEL SUB-ASSEMBLY
Click here![]()
4. INSPECT VACUUM WARNING SWITCH ASSEMBLY
(a) Start the engine and stop it after 1 or 2 minutes.
(b) Disconnect the connector from the vacuum warning switch assembly.
(c) Measure the resistance of the vacuum warning switch assembly.
Standard resistance:
10 kΩ minimum
(d) With the engine stopped, depress the brake pedal several times to release the vacuum in the brake booster assembly, and measure the resistance of the vacuum warning switch assembly.
Standard resistance:
Below 1 Ω
(e) Connect the connector to the vacuum warning switch assembly.
5. INSTALL FENDER APRON UPPER OUTER PANEL SUB-ASSEMBLY
Click here![]()
Was this page helpful?