Brake System (Other)
Inspection On Vehicle
In this manual: Brake System (Other)
~1min read
INSPECTION ON VEHICLE
PROCEDURE
1. CHECK BRAKE FLUID LEVEL IN RESERVOIR
(a) Check the fluid level. If the brake fluid level is below the MIN line, check for leaks and inspect the brake pads. If necessary, add brake fluid to the reservoir up to the MAX line after repair or replacement. Brake fluid: SAE J1703 or FMVSS No. 116 DOT 3 SAE J1704 or FMVSS No. 116 DOT 4 NOTICE: When topping up with a pipette, make sure it has not been used with mineral oil, water or contaminated brake fluid. Seals may deteriorate and cause fluid leaks, or the fluid may become contaminated, which reduces its effectiveness. |
![]() |
Was this page helpful?
