Supplemental Restraint Systems

Inspection On Vehicle

~2min read

INSPECTION ON VEHICLE

PRECAUTION / NOTICE / HINT

CAUTION:

Be sure to follow the correct removal and installation procedures for the door side airbag sensors.

PROCEDURE

1. INSPECT SIDE AIRBAG SENSOR (for Vehicle without Collision)

(a) Perform a diagnostic system check.

Click here

2. INSPECT SIDE AIRBAG SENSOR (for Vehicle with Collision without Airbag Deployment)

(a) Perform a diagnostic system check.

Click here

(b) If a front door of the vehicle, or the area around a front door, is damaged, visually inspect the door side airbag sensors for defects.

HINT:

Defects include the following:

  • Cracks in the sensor housing
  • Nicks in the sensor housing
  • Chips in the sensor housing
  • Cracks or other damage to the connector
  • Damage to the rubber seal
  • Label torn off or serial number illegible.

OK:

There are no defects.

If any of these defects are found, replace the door side airbag sensor with a new one.

3. INSPECT SIDE AIRBAG SENSOR (for Vehicle with Collision with Airbag Deployment)

(a) When the airbags have deployed due to a collision, be sure to replace all door side airbag sensors in the damaged areas (all those requiring repair).

(b) Visually inspect the door side airbag sensors in the undamaged areas for defects.

HINT:

Defects include the following:

  • Cracks in the sensor housing
  • Nicks in the sensor housing
  • Chips in the sensor housing
  • Cracks or other damage to the connector
  • Damage to the rubber seal
  • Label torn off or serial number illegible.

OK:

There are no defects.

If any defects are found, or if a door side airbag sensor has detected a severe collision, replace the door side airbag sensor with a new one.