Introduction

Air bag sensor front LH

11steps
~66min
3/5difficulty
0102030405017.513N·mlb·ft
Tightening torque found on this page
Done 0 of 11
COMPONENTS
REPLACEMENT
REPLACEMENT

HINT: COMPONENTS:

  1. PRECAUTION
  2. DISCONNECT BATTERY NEGATIVE TERMINAL
  3. REMOVE ENGINE UNDER COVER RH
  4. REMOVE AIR BAG FRONT RH SENSOR

a. Remove the bolt and front airbag sensor RH.

b. Disconnect the connector from the front airbag sensor

b. Disconnect the connector from the front airbag sensor RH.

HINT: Insert a screw driver in any of the three opening sections of the sensor and slide the sensor to disconnect it from the connector.

  1. INSPECT AIR BAG FRONT RH SENSOR
  2. INSTALL AIR BAG FRONT RH SENSOR
  3. Check that the ignition switch trun OFF.

  4. Check that the battery negative (−) terminal is disconnected.

NOTICE: Do not start the operation for 90 seconds after removing the terminal.
  1. Install the front airbag sensor RH with the bolt. Torque: 17,5 N·m
  2. Connect the connector to the front airbag sensor RH.

  3. Check that no play is identified.

7. INSPECT SRS WARNING LIGHT

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.