Toyota Camry Quiz
Introduction

Side air bag sensor assy RH

In this manual: Introduction
Introduction — 61Audio & visual system — 16Automatic transmission / trans — 19Transmission revolution (ATM) — 1Shift lock system (ATM) — 1Brake — 20Clutch — 10Communication system — 4Cooling — 15Cruise control — 3Drive shaft / propeller shaft — 9Emission control — 8Engine control system — 12Engine hood/door — 7Exhaust — 3Exterior/interior trim — 14Front suspension — 9Fuel — 12Heater & air conditioner — 16Ignition — 8Instrument panel/meter — 7Intake — 7Lighting — 11Lubrication — 16Manual transmission/transaxle — 13Parking brake — 10Power steering — 7Rear suspension — 10Seat — 12Service specifications — 26Sliding roof/convertible — 4Starting & charging — 11Starting system (2AZ−FE)(From July, 2003) — 1Starting system (1MZ−FE/3MZ−FE) — 1Steering column — 6Theft deterrent & door lock — 9Tire & wheel — 4Windshield/windowglass/mirror — 5Back window glass — 1Power window control system — 1Power mirror control system — 1Inner rear view mirror assy — 1Windshield glass — 1Wiring — 1
15steps
~90min
4/5difficulty
010203040502015N·mlb·ft
Tightening torque found on this page
Done 0 of 15
COMPONENTS
REPLACEMENT
REPLACEMENT

HINT:

  • Replacement procedure of the LH side is the same as that for the RH side.

  • Installation is in the reverse order of removal.

  1. PRECAUTION
  2. DISCONNECT BATTERY NEGATIVE TERMINAL
  3. REMOVE FRONT DOOR SCUFF PLATE RH
  4. REMOVE REAR DOOR SCUFF PLATE RH
  5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
  6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
  7. REMOVE CENTER PILLAR GARNISH LOWER RH
  8. REMOVE FRONT SEAT OUTER BELT ASSY RH
  9. REMOVE SIDE AIR BAG SENSOR ASSY RH

  10. Disconnect the connector from the side airbag sensor assy RH.

  11. Remove the 3 bolts and the side airbag sensor assy RH.

Remove side air bag sensor assy RH Remove side air bag sensor assy RH 10. INSTALL SIDE AIR BAG SENSOR ASSY RH

  1. Check that the ignition switch is off.

  2. Check that the battery negative (−) terminal is disconnected.

CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation. c. Install the side airbag sensor assy RH with the 3 bolts.Torque: 20 N·m NOTICE:
  • If the side airbag sensor assy RH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace the side airbag sensor assy RH with a new one.
  • When installing the side airbag sensor assy RH, be careful that the SRS wiring does not interfere with other parts and is not pinched between other parts.

  1. Connect the connector to the side airbag sensor assy RH.

  2. Check that there is no looseness in the installation parts of the side airbag sensor assy RH.

11. INSPECT SRS WARNING LIGHT

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.