Introduction

Air bag sensor front LH

11steps
~66min
3/5difficulty
0102030405017.513N·mlb·ft
Tightening torque found on this page
Done 0 of 11
COMPONENTS
REPLACEMENT
REPLACEMENT

HINT: COMPONENTS:

  1. PRECAUTION
  2. DISCONNECT BATTERY NEGATIVE TERMINAL
  3. REMOVE ENGINE UNDER COVER LH
  4. REMOVE AIR BAG SENSOR FRONT LH

a. Remove the bolt and front airbag sensor LH.

b. Disconnect the connector from the front airbag sensor

b. Disconnect the connector from the front airbag sensor LH.

HINT: Insert a screw driver in any of the three opening sections of the sensor and slide the sensor to disconnect it from the connector.

  1. INSPECT AIR BAG SENSOR FRONT LH
  2. INSTALL AIR BAG SENSOR FRONT LH
  3. Check that the ignition switch is off.

  4. Check that the battery negative (−) terminal is disconnected.

NOTICE: Do not start the operation for 90 seconds after removing the terminal.
  1. Install the front airbag sensor LH with the bolt. Torque: 17,5 N·m
  2. Connect the connector to the front airbag sensor LH.

  3. Check that no play is identified.

7. INSPECT SRS WARNING LIGHT

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.