Toyota Camry Quiz
Manual transmission/transaxle

Floor shift cable transmission control shift

In this manual: Manual transmission/transaxle
Introduction — 61Audio & visual system — 16Automatic transmission / trans — 19Transmission revolution (ATM) — 1Shift lock system (ATM) — 1Brake — 20Clutch — 10Communication system — 4Cooling — 15Cruise control — 3Drive shaft / propeller shaft — 9Emission control — 8Engine control system — 12Engine hood/door — 7Exhaust — 3Exterior/interior trim — 14Front suspension — 9Fuel — 12Heater & air conditioner — 16Ignition — 8Instrument panel/meter — 7Intake — 7Lighting — 11Lubrication — 16Manual transmission/transaxle — 13Parking brake — 10Power steering — 7Rear suspension — 10Seat — 12Service specifications — 26Sliding roof/convertible — 4Starting & charging — 11Starting system (2AZ−FE)(From July, 2003) — 1Starting system (1MZ−FE/3MZ−FE) — 1Steering column — 6Theft deterrent & door lock — 9Tire & wheel — 4Windshield/windowglass/mirror — 5Back window glass — 1Power window control system — 1Power mirror control system — 1Inner rear view mirror assy — 1Windshield glass — 1Wiring — 1
22steps
~132min
4/5difficulty
0102030405054N·mlb·ft
Tightening torque found on this page
Done 0 of 22
REPLACEMENT
  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB−ASSY
  2. REMOVE AIR CONDITIONING RADIATOR ASSY
  3. REMOVE AIR BAG SENSOR ASSY CENTER
  4. REMOVE FLOOR SHIFT CABLE TRANSMISSION CONTROL SHIFT
  5. Remove the clip and washer and separate the top of the shift cable from the transaxle.
  6. Remove the clip and shift cable from the control cable bracket.
  7. Turn the lock and separate the shift cable from the shift lever retainer.
  8. Separate the top of the shift cable from the shift lever assy.
  9. Remove the 2 retainer set bolts from the floor.
  10. Separate the retainer from the grommet.
  11. Remove the select cable from the grommet.
  12. Remove the shift cable through the floor hole and retainer.
Remove floor shift cable transmission control shift Remove floor shift cable transmission control shift 5. INSTALL FLOOR SHIFT CABLE TRANSMISSION CONTROL SHIFT
  1. Put the shift cable through the floor hole and retainer.
  2. Install the select cable to the grommet.
  3. Install the retainer to the grommet.
NOTICE: Fit 3 projections of the grommet into 3 holes of the retainer. d. Install the 2 retainer set bolts.Torque: 5 N·m Install floor shift cable transmission control shift Install floor shift cable transmission control shift

e. Connect the shift cable to the shift lever retainer.

NOTICE:
  • The projecting part of the cable outer should face upward when the shift cable is installed.
  • Make sure that after installation the cable outer lock is projecting from A shown in the illustration.
  1. Install the top of the shift cable to the shift lever assy.
  2. Connect the shift cable to the control cable bracket and install a new clip.
  3. Connect the shift cable to the transaxle and install the washer and clip.
  4. INSTALL AIR BAG SENSOR ASSY CENTER
  5. INSTALL AIR CONDITIONING RADIATOR ASSY
  6. INSTALL INSTRUMENT PANEL SAFETY PAD SUB−ASSY
  7. INSPECT SRS WARNING LIGHT

Test yourself

A quick Toyota Camry quiz: every answer comes with an explanation and a link to the manual page.