Audio & Visual & Telematics

Backup Battery Internal Electronic Failure (B15CC49)

~1min read

DESCRIPTION

This DTC is stored when the DCM (telematics transceiver) detects one of the following:

  • The mobilephone battery voltage drops or the mobilephone battery malfunctions.
  • The mobilephone battery temperature is (temporarily) high.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15CC49

Backup Battery Internal Electronic Failure

Mobilephone battery malfunction

  • Mobilephone battery
  • DCM (telematics transceiver)

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.

Click here

PROCEDURE

  1. CHECK DTC

(a) Turn the ignition switch to ON and wait for 10 seconds or more.

(b) Clear the DTCs.

Body Electrical > Telematics > Clear DTCs

(c) Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
OK

USE SIMULATION METHOD TO CHECK

NG
  1. CHECK MOBILEPHONE BATTERY

(a) Replace the mobilephone battery with a normal one and check if the same problem occurs again.

NOTICE:

  • The mobilephone battery must not be replaced while an ACN call is in progress.

    Click here

  • After replacing the mobilephone battery, perform initialization.

    Click here

(b) Clear the DTCs.

Body Electrical > Telematics > Clear DTCs

(c) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes

OK:

No DTCs are output.

OK

PERFORM INITIALIZATION

NG
  1. REPLACE DCM (TELEMATICS TRANSCEIVER)

(a) Replace the DCM (telematics transceiver) with a new one.

Click here

NOTICE:

  • The ignition switch must be off.
  • Do not exchange the DCM (telematics transceiver) with one from another vehicle.
NEXT

PERFORM DCM ACTIVATION