Audio & Visual & Telematics

Red Indicator Remains On

~1min read

DESCRIPTION

This means that the DCM (telematics transceiver) has detected a malfunction in the safety connect system and stored a DTC or specific vehicle control history (RoB) Code.

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.

Click here

PROCEDURE

  1. CHECK DTC

(a) Turn the ignition switch to ON and wait for 10 seconds or more.

(b) Clear the DTCs.

Body Electrical > Telematics > Clear DTCs

(c) Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes

OK:

No DTCs are output.

NG

GO TO DIAGNOSTIC TROUBLE CODE CHART

OK
  1. CHECK VEHICLE CONTROL HISTORY (RoB)

(a) Check for vehicle control history and note any codes that are output.

Body Electrical > Telematics > Utility

Vehicle Control History (RoB)

Result

Proceed to

No vehicle control history is output

A

Any vehicle control history is output

B

B

GO TO VEHICLE CONTROL HISTORY

A
  1. REPLACE DCM (TELEMATICS TRANSCEIVER)

(a) Replace the DCM (telematics transceiver) with a new one.

Click here

NOTICE:

  • The ignition switch must be off.
  • Do not exchange the DCM (telematics transceiver) with one from another vehicle.
NEXT

PERFORM DCM ACTIVATION