Emergency Call Switch Illumination Circuit
WIRING DIAGRAM
NOTICE:
- Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.
Click here
.gif)
- Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (MAP LIGHT ASSEMBLY POWER SOURCE)
(a) Disconnect the I200 DCM (telematics transceiver) connector.
(b) Disconnect the T6 map light assembly (manual [SOS] switch) connector.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
T6-14 (RRID) - Body Ground |
Ignition switch ON |
11 to 14 V |
(d) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
I200-3 (SIG-) - T6-8 (GND3) |
Always |
Below 1 Ω |
I200-3 (SIG-) or T6-8 (GND3) - Body ground |
Always |
10 kΩ or higher |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
INSPECT MAP LIGHT ASSEMBLY (MANUAL [SOS] SWITCH)
(a) Remove the map light assembly (manual [SOS] switch). Click here |
|
(b) Apply auxiliary battery voltage to the connector.
Measurement Condition | Condition | Specified Condition |
|---|---|---|
Auxiliary battery positive (+) → 14 (RRID) Auxiliary battery negative (-) → 8 (GND3) |
Always |
Manual (SOS) switch illumination comes on |
(c) Check if the manual (SOS) switch illumination comes on.
OK:
The manual (SOS) switch illumination comes on.
| NG | REPLACE MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH) |
|
REPLACE DCM (TELEMATICS TRANSCEIVER)
(a) Replace the DCM (telematics transceiver) with a new one.
Click here ![]()
NOTICE:
- The ignition switch must be off.
- Do not exchange the DCM (telematics transceiver) with one from another vehicle.
| NEXT | PERFORM DCM ACTIVATION |
