Drivetrain
Installation
In this manual: Drivetrain
~1min read
2special tools
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
REAR NO. 1 DIFFERENTIAL MOUNT CUSHION |
41651 |
- |
- |
|
2 |
CHARCOAL CANISTER ASSEMBLY |
77740 |
- |
- |
- |
3 |
REAR DIFFERENTIAL CARRIER ASSEMBLY |
41110 |
- |
- |
- |
PROCEDURE
1. INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION
*1 |
Rear Suspension Member Sub-assembly |
- |
- |
*a |
-3° to 3° |
*b |
Arrow Mark |
*c |
5.0 to 6.0 mm (0.197 to 0.236 in.) |
*d |
Turn |
*e |
Hold |
- |
- |
![]() |
Front of Vehicle |
![]() |
SST Bolt Position |
(1) Using SST, install a new rear No. 1 differential mount cushion to the rear suspension member sub-assembly.
SST: 09316-20011
SST: 09570-24011
NOTICE:
- Be sure to install the rear No. 1 differential mount cushion so that the arrow mark faces the upper of the vehicle.
- Make sure that the rear No. 1 differential mount cushion is aligned within 3° from the center.
- Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.
- Before using SST, apply grease to SST bolt.
- Be sure to use the correct combination of SST.
- Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.
- Do not tilt the bolt of SST.
2. INSTALL CHARCOAL CANISTER ASSEMBLY
Click here ![]()
3. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
Click here ![]()
Was this page helpful?
.png)
.png)
.png)
.gif)
.png)
.png)