Drivetrain

Removal

~2min read
2special tools

REMOVAL

COMPONENTS (REMOVAL)

Procedure

Part Name Code

1

REAR DIFFERENTIAL CARRIER ASSEMBLY

41110

-

-

-

2

CHARCOAL CANISTER ASSEMBLY

77740

-

-

-

3

REAR NO. 1 DIFFERENTIAL MOUNT CUSHION

41651

-

-

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear No. 1 differential mount cushion removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replacement Part or Procedure

Necessary Procedures

Effect/Inoperative Function When Necessary Procedures are not Performed

Link

Rear wheel alignment adjustment

  • Perform "Reset Memory"
  • Perform "Calibration"
  • DTCs are stored
  • ABS warning light illuminates
  • Slip indicator light illuminates
  • Electronically controlled brake system does not operate correctly

Reset memory

Dynamic torque control AWD system

Suspension, tires, etc.

Rear television camera assembly optical axis (Back camera position setting)

Parking assist monitor system

Initialize headlight ECU sub-assembly LH

Automatic headlight beam level control system

PROCEDURE

1. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

Click here

2. REMOVE CHARCOAL CANISTER ASSEMBLY

Click here

3. REMOVE REAR NO. 1 DIFFERENTIAL MOUNT CUSHION

*1

Rear Suspension Member Sub-assembly

-

-

*a

Turn

*b

Hold

Front of Vehicle

SST Bolt Position

(1) Using SST, remove the rear No. 1 differential mount cushion from the rear suspension member sub-assembly.

SST: 09316-20011

SST: 09570-24011

NOTICE:

  • Do not bring SST (09316-20011) into contact with the rear suspension member sub-assembly.
  • Before using SST, apply grease to SST bolt.
  • Be sure to use the correct combination of SST.
  • Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.
  • Do not tilt the bolt of SST.