Vehicle Interior

Personal Light

~2min read

Removal

REMOVAL

COMPONENTS (REMOVAL)

Procedure

Part Name Code

1

MAP LIGHT ASSEMBLY

81260A

-

-

2

MAP LIGHT ASSEMBLY

81260A

-

-

*A

w/o Sliding Roof

*B

w/ Sliding Roof

PROCEDURE

1. REMOVE MAP LIGHT ASSEMBLY (w/o Sliding Roof)

(1) Using a moulding remover D, disengage the clips to remove the map light assembly.

(2) Disconnect the connector.

2. REMOVE MAP LIGHT ASSEMBLY (w/ Sliding Roof)

(1) Using a moulding remover D, disengage the clips and guides to remove the map light assembly.

(2) Disconnect the connector.

Inspection

INSPECTION

PROCEDURE

1. INSPECT MAP LIGHT ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

T6-2 (RLMP) - T6-3 (DOOR)

Door linked switch on

Below 1 Ω

T6-2 (RLMP) - T6-17 (GND)

Dome light switch on

Below 1 Ω

If the result is not as specified, replace the map light assembly.

*a

Component without harness connected

(Map Light Assembly)

(b) Check the illumination.

(1) Apply auxiliary battery voltage to the map light assembly and check that the lights illuminate.

OK:

Tester Connection

Condition

Specified Condition

T6-4 (+B1) - Auxiliary battery positive (+)

T6-17 (GND) - Auxiliary battery negative (-)

Map light switch LH on

Map light LH illuminates

T6-4 (+B1) - Auxiliary battery positive (+)

T6-17 (GND) - Auxiliary battery negative (-)

Map light switch RH on

Map light RH illuminates

T6-4 (+B1) - Auxiliary battery positive (+)

T6-17 (GND) - Auxiliary battery negative (-)

Map light switches off and dome light switch on

Map light LH and RH illuminate

T6-4 (+B1) - Auxiliary battery positive (+)

T6-3 (DOOR) - Auxiliary battery negative (-)

Map light switches off and door linked switch on

Map light LH and RH illuminate

If the result is not as specified, replace the bulb or map light assembly.

*a

Component without harness connected

(Map Light Assembly)

Installation

INSTALLATION

COMPONENTS (INSTALLATION)

Procedure

Part Name Code

1

MAP LIGHT ASSEMBLY

81260A

-

-

-

2

MAP LIGHT ASSEMBLY

81260A

-

-

-

*A

w/o Sliding Roof

*B

w/ Sliding Roof

PROCEDURE

1. INSTALL MAP LIGHT ASSEMBLY (w/o Sliding Roof)

2. INSTALL MAP LIGHT ASSEMBLY (w/ Sliding Roof)