Power Back Door Touch Sensor
Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
POWER BACK DOOR UNIT ASSEMBLY SET |
68920 |
- |
- |
- |
2 |
POWER BACK DOOR SENSOR ASSEMBLY |
84280D |
- |
- |
- |
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE POWER BACK DOOR UNIT ASSEMBLY SET
Click here ![]()
2. REMOVE POWER BACK DOOR SENSOR ASSEMBLY
Inspection
INSPECTION
PROCEDURE
1. INSPECT POWER BACK DOOR SENSOR ASSEMBLY RH
*a |
Component without harness connected (Power Back Door Sensor Assembly RH) |
*b |
Not Pressed |
*c |
Pressed |
- |
- |
(a) Check the resistance of the power back door sensor Assembly RH.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
U15-1 (OSR)- U15-2 (OSRE) |
Not pressed |
950 Ω to 1050 Ω |
U15-1 (OSR)- U15-2 (OSRE) |
Pressed |
Below 100 Ω |
If the result is not as specified, replace the power back door sensor Assembly RH.
2. INSPECT POWER BACK DOOR SENSOR ASSEMBLY LH
*a |
Component without harness connected (Power Back Door Sensor Assembly LH) |
*b |
Not Pressed |
*c |
Pressed |
- |
- |
(a) Check the resistance of the power back door sensor Assembly LH.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
U16-1 (OSL)- U16-2 (OSLE) |
Not pressed |
950 Ω to 1050 Ω |
U16-1 (OSL)- U16-2 (OSLE) |
Pressed |
Below 100 Ω |
If the result is not as specified, replace the power back door sensor Assembly LH.
Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
POWER BACK DOOR SENSOR ASSEMBLY |
84280D |
- |
- |
- |
2 |
POWER BACK DOOR UNIT ASSEMBLY SET |
68920 |
- |
- |
- |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL POWER BACK DOOR SENSOR ASSEMBLY
Torque:
1,2 N·m {13 kgf·cm, 11 in·lbf}
2. INSTALL POWER BACK DOOR UNIT ASSEMBLY SET
Click here ![]()
.png)
.png)
.png)
.png)
.png)
.png)
.png)