Toyota Corolla Quiz
Brake

Replacement

In this manual: Brake
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
4steps
~24min
2/5difficulty
Done 0 of 4
1. Remove proportioning valve assy
Toyota Corolla. Remove proportioning valve assy
  1. Using sst, disconnect the 5 brake tubes from the proportioning valve assy.

    Sst 09023–00100

    Toyota Corolla. Remove proportioning valve assy
  2. Remove the 2 bolts and proportioning valve assy from the body.
2. Install proportioning valve assy
Toyota Corolla. Install proportioning valve assy
  1. Install the proportioning valve assy with the 2 bolts.

    Torque: 5.4 Nvm (55 Kgf·cm, 48 invlbf)

    Toyota Corolla. Install proportioning valve assy
  2. Using sst, connect the 5 brake tubes to the proportioning valve assy.

    Sst 09023–00100
    torque: 15.2 Nvm (155 Kgf·cm, 11 ft·lbf)

3. Fill reservoir with brake fluid 4. Bleed master cylinder

sst 09023–00100

5. Bleed brake line 6. Check fluid level in reservoir

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.