Toyota Corolla Quiz
Exterior/interior trim

Replacement

In this manual: Exterior/interior trim
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
12steps
~72min
3/5difficulty
Done 0 of 12
Hint

: installation is in the reverse order of the removal. But the installation is indicated only when it has a point

. 1. Remove radiator grille sub–assy
Toyota Corolla. Remove radiator grille sub–assy
  1. Remove the 2 bolts and clip.
  2. using a screwdriver, remove the radiator grille.
Hint

: tape the screwdriver tip before use.

 2. Remove front bumper cover
Toyota Corolla. Remove front bumper cover
  1. Remove the 6 screws and 2 clips.
  2. disengage the hook, and remove the front bumper cover.
  3. w/ fog light: disconnect the fog light connectors.
3. Remove front bumper energy absorber 4. Remove front bumper reinforcement
Toyota Corolla. Remove front bumper reinforcement
  1. Disconnect the wire harness clamp.
  2. remove the 4 nuts and front bumper reinforcement.
5. Remove front bumper side mounting bracket lh 6. Remove front bumper side mounting bracket rh 7. Remove front lh spoiler sub–assy (w/ front spoiler)
  1. remove the screw and 4 retainers.
  2. disengage the clip and front lh spoiler.
  3. employ the same manner described above to the other side.
8. Remove front rh spoiler sub–assy (w/ front spoiler) 9. Remove fog light unit lh (w/ fog light)
  1. remove the nut and fog light unit.
  2. employ the same manner described above to the other side.
10. Remove fog light unit rh (w/ fog light) 11. Remove front bumper hole cover lh (w/o fog light) 12. Remove front bumper hole cover rh (w/o fog light) 13. Install front bumper reinforcement
Toyota Corolla. Install front bumper reinforcement
  1. Install the front bumper reinforcement with the 4 nuts.

    Torque: 36 nvm (367 kgfvcm, 27 ftvlbf)

14. Install radiator grille sub–assy
Toyota Corolla. Install radiator grille sub–assy
  1. Install the radiator grille with the 2 bolts and clip.

    Torque: 5.0 Nvm (51 kgfvcm, 44 in.Vlbf)

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.